Polymer Nation P-30 Epoxy Grout Coat / Primer

Polymer Nation P-30 is most often used to fill porous surfaces-like trowel applied epoxy flooring and coving and as a concrete block filler. It can also be used as a troweling paste to assist in the application of aggregate-filled mortar on coving and vertical substrates.

SKU: N/A Categories: ,

Description

Polymer Nation P-30 consist of a high viscosity, nonylphenol-free, epoxy resin (E2) and a thickened, cycloaliphatic amine reactant (H3). This combination achieves a rheology that makes it easy to spread but also fast to return to its resting state.

Description Results Notes
Kit Yield in Gallons 3 Material can be supplied in larger packaging upon request and with minimum quantities
Number of Components 2 1-2 gallon container of Part A and 1-1 gallon container of Part B
Mix Ratio Liquids by Volume 2:1 It is always preferred to mix the entire kit, whenever possible, to avoid off-ratio mixtures
Ideal Application Temperatures 60F-90F Verify that substrate temperature is above 5 degrees of dewpoint during application and cure of material to avoid a potential amine blush
Mixed Viscosity in cP@25C/77F 4500 +/- 500 Warmer temperatures will reduce viscosity and lower temperatures will increase viscosity
Gel Time 45 min. Warmer temperatures will decrease gel time and lower temperatures will increase gel time
Dry to Touch 4 Hours Warmer temperatures will reduce time and colder temperatures will increase time
Through Dry 8 Hours Warmer temperatures will reduce time and colder temperatures will increase time
Dry to Walk 12 Hours Warmer temperatures will reduce time and colder temperatures will increase time
Dry to Lightly Use 24 Hours Warmer temperatures will reduce time and colder temperatures will increase time
Full Cure 7 Days Warmer temperatures will reduce time and colder temperatures will increase time
Shore Hardness at 24 hours D65 Warmer temperatures will increase hardness
Shore Hardness at 7 days D78 Warmer temperatures will shorten time to reach full hardness
Gloss @ 60 Degree Angle 80-85 Applying material close to dew point will decrease gloss and may result in an amine blush
VOC’s of Mixed Material <50g/L EPA Method 24
Color Scale per ASTM D1500 .5-1.0 Clear to slightly amber before filler is introduced
Solids by Volume Mixed 100%
Storage 60F-90F Store material between 60-90 degrees F in a protected dry location.
Odor Subtle Measuring odor offensiveness is difficult so experience with chemicals has been consulted here
Application Thickness in Mils 12-20 mils depending on porosity of substrate
Disposal Dispose of  material, containers, solvents, etc. per Federal, State and local guideline, rules and laws
Available Colors Clear
Mixing & Installation Combine all of part A and B into a single container, large enough to accept the entire kit. Mix at 350 RPM for 2-3 minutes using an appropriate mixing blade and making sure not to introduce excessive air into the solution. If using as a block filler- pour content into a large rolling pan and roll with a 9″ wide, 5/8″ nap roller cover. If using as a grout coat, pour the entire content from the container onto the floor and using a non-marking, flat squeegee,  apply even pressure to force material into the pores and cavities being careful not to leave tails that will need to be removed once cured. Recoat within 24 hours. Clean tools with a solvent similar to Xylene or Acetone.
Polymer Nation believes the information contained herein to be true and accurate. Information contained herein is for evaluation purposes only.

Additional information

P-30 Packaging

3 Gallon Kit